SKU:

For Fleetwood 246063 Power Gear Slide Out Controller RV Slide-out Relay Control Board 14-1130 / 140-1130
适用于Fleetwood 246063 房车动力齿轮 继电器控制板 14-1130 / 140-1130
条码：6922288226900
HSCode：39259000
批量修改原始型号 		采购：Felix  编辑：Ellie  产品经理：caifeng

1. The power gear 14-1130 and 140-1130 are relay boards that have high power relays that route the power to the electric motors for your Power Gear Slide Out System.
2. The same fuse and breaker that is on the old board may be used on the new 140-1130. The 140-1130 controller will need the center wire on the wall switch to be a 12VDC (positive trigger) which on some models of controllers such as the 14-1098 are ground trigger.
3. If the Relay board you took out has the part number 14-1130 or 140-1130 than this board will drop in. And you just need to move over your Thermal Circuit Breaker and Glass Fuse from your older board firstly then install them back.
4. Remount the replacement control, reinstall the circuit breaker and glass fuse, reconnect the 6-pin connector to the control module.
5. Replace Number For RV: 14-1130, 140-1130


1. 动力齿轮 14-1130 和 140-1130 是具有大功率继电器的继电器板，可将电力输送到动力齿轮滑出系统的电动机。
2. 旧板上的保险丝和断路器可以用在新的 140-1130 上。 140-1130 控制器需要墙壁开关上的中心线为 12VDC（正触发），在某些型号的控制器（例如 14-1098）上为接地触发。
3. 如果您取出的继电器板的部件号为 14-1130 或 140-1130，则此板将放入。您只需先将旧板上的热断路器和玻璃保险丝移开，然后再安装回去 .
4. 重新安装替换控制，重新安装断路器和玻璃保险丝，将 6 针连接器重新连接到控制模块。
5. 更换房车号码：14-1130、140-1130


代码：

Specification:
Package weight
One package Weight 0.1kgs / 0.22lb
One Package Size 10.0cm * 5.0cm * 3.0cm / 3.94inch * 1.97inch * 1.18inch
Qty per Carton 250
Carton Weight 26.5kgs / 58.42lb
Carton Size 42cm * 32cm * 28cm / 16.54inch * 12.6inch * 11.02inch

代码：