SKU:

Wintact WT8812 Compound Gas Monitor Detection Alarm
Wintact WT8812 复合式气体检测报警器
条码：6922589170636
HSCode：90303390
批量修改原始型号 		采购：Colin  编辑：Ellie  产品经理：Maura

1. Gas measurement: The sensor warms up when the countdown is started. The refresh rate is 1HZ. Do not charge during the measurement of combustible gas, otherwise it may explode.
2. High/low alarm: 4 default high/low alarms, 4 types of alarms, and the alarm sound can be turned off.
3. Data recording: 1000 pieces of data can be recorded. The default interval of data recording is 5 seconds, which can be set in inL of the setting mode. When the interval is set to 0 seconds, the data logging function fails. The delete operation will delete all recorded data.
4. Temperature display: set the unit to Celsius or Fahrenheit, the default unit is Celsius
5. Automatic shutdown: automatic shutdown without operation within 30 minutes. This feature is turned on by default.
6. Battery capacity: It is forbidden to start the unit to avoid measurement errors or explosion. If the battery is low, it may turn off automatically. Charging time: about 4 hours. Discharge time: about 8 hours.
7. Zero point calibration: It is recommended to calibrate the device at zero point or zero offset every month to ensure the high accuracy of the measurement (please ensure that the battery power is above 2bar) calibration, and place it in the air for a period of time after powering on. Make sure that the device body temperature is slightly higher than the ambient temperature.
8. Temperature compensation: the measured data is compensated within the range of -20 to 50 degrees Celsius
9. Software error: The machine crashes/shutdown indicates that an error occurred during the operation. If the software is forced to shut down, please press the on/off button to activate the device
10. Adopt high-quality gas sensor, safe and reliable, accurate measurement and stable performance.
11. It has excellent sensitivity and repeatability, is easy to use and maintain, and meets the requirements for high reliability of equipment in industrial field safety monitoring.
12. The shell is made of high-strength engineering plastics and composite non-slip rubber, dust-proof and explosion-proof, high strength, smooth hand feeling
13. Battery type: 3. 7V rechargeable lithium battery
14. LCD displays real-time data and system status
15. Response time (90%): less than 30 seconds
16. Size: 71x153x49mm
17. Weight: 218.7g


1. 气体测量：传感器在开机倒计时时预热。刷新频率为1HZ。测量可燃气体过程中请勿充电，否则可能发生爆炸。
2. 高/低报警：4个高/低报警默认值，4种报警形式，可关闭报警声音。
3. 数据记录：可记录1000条数据。数据记录的默认间隔为 5 秒，可在设置模式的 inL 中设置。当间隔设置为 0 秒时，数据记录功能失败。删除操作将删除所有记录的数据。
4. 温度显示：设置单位为摄氏度或华氏度，默认单位为摄氏度
5. 自动关机：30分钟内无操作自动关机。默认开启是这个功能。
6. 电池容量：禁止启动机组运行，以免发生测量错误或爆炸。如果电池电量低，它可能会自动关闭。充电时间：约4小时。放电时间：约8小时。
7. 0点校准：建议每月在0点或出现零位偏移时对设备进行校准，以确保测量的高精度（请确保电池电量在2bar以上）标定，开机后在空气中放置一段时间，确保设备体温略高于环境温度。
8. 温度补偿：测量数据在-20到50摄氏度范围内进行补偿
9. 软件错误：本机死机/关机表示操作过程中发生错误。如果软件强制关机，请按开/关按钮激活设备
10. 采用优质气体传感器，安全可靠，测量准确，性能稳定。
11. 具有优良的灵敏度和重复性，易于使用和维护，满足工业现场安全监控对设备高可靠性的要求。
12. 壳采用高强度工程塑料和复合防滑橡胶，防尘防爆，强度高，手感光滑
13. 电池种类：3. 7V可充电锂电池
14. LCD显示实时数据和系统状态
15. 响应时间 (90%)：少于 30 秒
16. 尺寸：71x153x49mm
17. 重量：218.7g


代码：

Specification:
Package weight
One package Weight 0.87kgs / 1.92lb
One Package Size 27.0cm * 18.0cm * 5.0cm / 10.63inch * 7.09inch * 1.97inch
Qty per Carton 10
Carton Weight 11.35kgs / 25.02lb
Carton Size 52cm * 41cm * 32cm / 20.47inch * 16.14inch * 12.6inch

代码：