SKU:

Color Screen Version Graphic Display M328 Transistor Tester Resistance Meter Inductance Meter Capacitance Meter ESR Meter
彩屏版图形显示 M328晶体管测试仪 电阻表电感表电容表ESR仪表
条码：6922146085285
HSCode：90303390
批量修改原始型号 		采购：Kitty  编辑：Shadow  产品经理：Maura


1. Supported languages: Simplified Chinese, Traditional Chinese, English (switch between three languages)
2. Dimensions: 70mmx135mmx24mm
3. Power supply: DC9V (need to provide its own 9V stacked battery 6F22)
4. Weight: 0.128kg (excluding battery)
5. Operating instructions: 1,2,3 pins can be connected at will, automatically identify the type, automatically detect the pin sequence, graphical display, and automatically measure parameters. Full fool operation.
6. Transistor range: 2 or less (including 2) PN junction transistors, do not have other internal resistance and capacitance original.
7. Resistance measurement 0.5Ω-50MΩ
8. Inductance measurement 0.01mH-20H
9. Capacitance measurement 25pf-100000uF
10. Function introduction:
- One-key measurement operation, power off automatically after delay. The shutdown current is only 20nA, which supports battery operation.
- Automatic detection of PNP and NPN bipolar transistors, N, P-channel MOSFETs, JFET field effect transistors, diodes, dual diodes, thyristors, resistance, capacitance, inductance. Automatically detect pin definitions.
- Measure the current amplification factor (B) and the conduction voltage (Uf) of the bipolar transistor. Darlington transistors can be identified by high threshold voltage and high current amplification factor.
- The protection diode inside the bipolar transistor and MOSFET can be detected and displayed on the screen.
- Measure the threshold voltage and gate capacitance of MOSFET.
- Support the measurement of two resistances, the potentiometer can also measure. If the potentiometer is adjusted to one end of it, the tester cannot distinguish between the middle and both ends of the pin.
- The resolution of resistance measurement is 0.1 ohm, and the highest measured value is 50M ohm.
- The capacitance measurement range is from 25pf to 100mF (100,000 UF). The resolution can reach 1 pF, and the measuring range of the inductance is 0.01MH-20H, otherwise it will be displayed as resistance. If the DC resistance value of the inductance is higher than 2100 ohms, it will also be displayed as resistance. During the capacitance test, the VLoss displayed on the screen are loss and attenuation. The larger the value, the closer the capacitance is to scrapping! ESR is impedance, the smaller the value, the better the capacitor performance!
- It can detect the equivalent series resistance (ESR) of capacitors above 2UF with a resolution of 0.01 ohm. This function is very important for detecting capacitor performance.
- The symbols of the correct direction can be displayed for both diodes, and the forward voltage drop can be displayed at the same time.
- The LED is detected as a diode, and the forward voltage drop is higher than the normal value. The dual light emitting diode is detected as a dual diode. At the same time, the LED will flash.
- The time of each test is about two seconds, only the measurement of large capacitance and inductance will take a long time
11. Important note: All capacitors must be discharged before testing.



1. 支持语言：简体中文，繁体中文，英文（三种语言任意切换)
2. 外观尺寸：70mmX135mmX24mm
3. 供电：DC9V（需自备9V层叠电池6F22）
4. 重量：0.128kg（不包含电池）
5. 操作说明：1,2,3引脚随意接，自动识别类型，自动检测引脚顺序，图形显示，自动测量参数。全傻瓜操作.
6. 晶体管范围：2个以下（包含2个）PN结组成的晶体管，内部不要有其他阻容原件的。
7. 电阻测量0.5Ω-50MΩ
8. 电感测量0.01mH-20H
9. 电容测量25pf - 100000uF
10. 功能介绍：
- 一键测量操作，延时自动关闭电源。关断电流只有20nA，支持电池操作。
- 自动检测PNP和NPN型双极晶体管，N、P沟道MOSFET，JFET场效应管，二极管，双二极管，可控硅，电阻，电容，电感。自动检测引脚定义。
- 测量双极型晶体管的电流放大系数（B）和发射结的导通电压（Uf）。达林顿晶体管可以通过高阈值电压和高电流放大系数识别。
- 可以检测出双极型晶体管和MOSFET内部的保护二极管并显示在屏幕上。
- 测量MOSFET的阈值电压和栅极电容值。
- 支持两个电阻的测量，电位器也可以测量。如果电位器调整到它的一端，则测试仪不能分辨中间和两端的引脚。
- 电阻测量的分辨率是0.1欧姆，最高测量值达50M欧姆。
- 电容测量范围从25pf到100mF（10万UF）。分辨率可达1 pF，电感测量范围为0.01MH-20H，否则会显示为电阻，如果电感的直流电阻值高于2100欧也会显示为电阻。 电容测试时，屏幕上显示的VLoss是损耗、衰减的意思这个值越大，电容越接近报废啦！ESR是阻抗，这个数值越小，电容性能越好！
- 可以检测2UF以上的电容器的等效串联电阻（ESR），分辨率为0.01欧姆。此功能对于检测电容性能非常重要。
- 可以对两个二极管显示正确方向的符号，同时显示正向压降。
- LED检测为二极管，正向压降比正常值偏高。双发光二极管检测为双二极管。检测同时发光二极管会闪亮。
- 每次测试的时间是大约两秒钟，只有大电容和电感测量会需要较长的时间
11. 重要提示：所有电容测试前都要先放电。


代码：

Specification:
Package weight
One package Weight 0.14kgs / 0.31lb
One Package Size 10.0cm * 18.0cm * 5.0cm / 3.94inch * 7.09inch * 1.97inch
Qty per Carton 194
Carton Weight 30kgs / 66.14lb
Carton Size 50cm * 50cm * 60cm / 19.69inch * 19.69inch * 23.62inch

代码：