SKU:

PWM Controller Module LED Signal Pulse Generator(ZK-PP2)
PWM控制器模块 LED信号脉冲发生器(ZK-PP2)
条码:6922972249179
HSCode:90329000
批量修改原始型号
采购:Felix  编辑:Leah  产品经理:Maura


1. LED brightness adjustment, frequency and duty cycle can be adjusted
2. Motor speed adjustment, frequency and duty cycle are adjustable
3. Drive the solenoid valve to engage and release, automatically cycle, delay output, cycle number (or infinite cycle) can be set
4. Control the on and off of equipment, conduct switch fatigue tests, voltage sag and other tests to verify the reliability of customer equipment
5. Delay start load, the delay time can be set, it will always be on or work intermittently after the delay
6. Can directly drive LEDs, motors, solenoid valves and other loads
7. Two modes can be selected: PWM mode - frequency (continuous), duty cycle, and number of pulses are adjustable; PULSE pulse mode - positive pulse width time, negative pulse width time, power-on delay start time, pulse The number is adjustable
8. Equipped with start and stop buttons to control signal output and stop
9. Wide voltage input: 3.3-30V, 5.08mm terminal wiring
10. Working voltage: 3.3~30V (be careful not to reverse the positive and negative poles, otherwise they may burn)
11. Frequency range: 1Hz~150KHz. Generally, 20KHz is selected for motor speed regulation.
12. Number of pulses: 1-9999, or infinite (display ‘----’ means infinite)
13. Delay output time: 0.000s-9999s, can be set to 1ms (MIN)
14. Positive and negative pulse width length: 0.000s-9999s, 1msMIN can be set)
15. Output load capacity: less than 8A (MOS switch tube)
16. Output amplitude: The amplitude is equal to the supply voltage (OUT+ and V+ modules are directly connected internally)
17. Dimensions: 60x32mm
18. Weight: 20 grams

1. LED亮度调节,频率、占空比可调节
2. 电机转速调节,频率、占空比可调节
3. 驱动电磁阀吸合和释放,自动循环,延时输出、循环次数(或无限循环)可设置
4. 控制设备的导通与关断,做开关疲劳试验、电压暂降等试验,验证客户设备的可靠性
5. 延时启动负载,延时时间可设,延时后一直导通或间歇工作
6. 可直接驱动LED、电机、电磁阀等负载
7. 两种模式可以选择:PWM模式——频率(连续)、占空比、脉冲个数可调;PULSE脉冲模式——正脉宽时间、负脉宽时间、上电延时启动时间、脉冲个数可调
8. 带启动停止按钮,可控制信号的输出与停止
9. 宽电压输入:3.3-30V,5.08mm端子接线
10. 工作电压:3.3~30V (注意正负极不要接反,否则可能会烧毁)
11. 频率范围:1Hz~150KHz 电机调速一般选择20KHz
12. 脉冲个数:1-9999,或无穷个(显示‘----’代表无穷个)
13. 延时输出时间:0.000s-9999s,可设置1ms(MIN)
14. 正、负脉宽长度:0.000s-9999s,可设置1msMIN)
15. 输出带载能力:小于8A (MOS开关管)
16. 输出幅值:幅值与供电电压相等(OUT+与V+模块内部直连)
17. 尺寸:60x32毫米
18. 重量:20克
代码:

Specification:
Package weight
One package Weight 0.03kgs / 0.07lb
One Package Size 10.0cm * 7.0cm * 4.0cm / 3.94inch * 2.76inch * 1.57inch
Qty per Carton 160
Carton Weight 5.9kgs / 13.01lb
Carton Size 42cm * 37cm * 34cm / 16.54inch * 14.57inch * 13.39inch

代码: