SKU:

80W 5A DC-DC Adjustable Voltage Regulator Battery Charging Module
80W 5A DC-DC可调稳压电源电池充电模块
条码：6922776203095
HSCode：90329000
批量修改原始型号 		采购：Felix  编辑：Randi  产品经理：Maura


Protection mechanism:
1. Input anti-reverse connection: yes
2. Output backflow prevention: yes
3. Input undervoltage protection: 4.7-30V adjustable, default 4.7V
4. Output over-voltage protection: 0-37V adjustable, default 37V
5. Output overcurrent protection: 0-5.2A adjustable, default 5.2A
6. Output over power protection: 0-82W adjustable, default 82W
7. Over-temperature protection, default 100 degrees celsius
8. Timeout protection: 0-100H adjustable, default off
9. Over capacity protection: 0-9999AH adjustable, default off
10. Super energy protection: 0-9999WH adjustable, default off

Parameters:
1. Input voltage: 6.0-36V
2. Output voltage: 0.6-36V
3. Output current: 0-5.0A
4. Voltage accuracy: the error does not exceed 0.5 percent+1 word
5. Output power: 80W
6. Current accuracy: error of no more than 0.5 percent + 3 words
7. Voltage resolution: 0.01V
8. Current resolution: 0.001A
9. Conversion efficiency: 88 percent or so
9. Soft start: yes
10. Size: 79 x 43 x 25mm

Notes:
1. Electronic module for a kind of electronic components, the purchase must have the basis for use
2. Please look at the product picture and description before purchase, otherwise it is easy to buy the wrong or cause damage
3. After purchase, please use it according to the parameters, otherwise it will be damaged
4. Power supply is very important, DC products must be a standard DC voltage, (i.e., a complete rectifier, filtering, voltage regulator), otherwise it can not be used or will cause damage to the product
5. Pay attention to the output connected to the battery, capacitor, positive and negative poles do not reverse, reverse direct scrapped
6. Connect inductive loads such as fans, motors, etc., start-up current is large, please leave 2-3 times the margin, that is, 35W can only use the current 1-2A or less, the power is about 10W or less
7. When boosting, if the input voltage is low, the output will be limited



保护机制：
1. 输入防反接：有
2. 输出防倒灌：有
3. 输入欠压保护：4.7-30V可调，默认4.7V
4. 输出过压保护：0-37V可调，默认37V
5. 输出过流保护：0 -5.2A可调，默认5.2A
6. 输出过功率保护：0-82W可调，默认82W
7. 过温保护有，默认100摄氏度
8. 超时保护：0-100H可调，默认关闭
9. 超容量保护：0-9999AH可调，默认关闭
10. 超能量保护：0-9999WH可调，默认关闭

参数：
1. 输入电压：6.0-36V
2. 输出电压：0.6-36V
3. 输出电流：0-5.0A
4. 电压精度：误差不超过百分之0.5+1个字
5. 输出功率：80W
6. 电流精度：误差不超过百分之0.5+3个字
7. 电压分辨率：0.01V
8. 电流分辨率：0.001A
9. 转换效率：百分之88左右
9. 软启动：有
10. 尺寸：79 x 43 x 25mm

注意事项：
1. 电子模块为电子元器件的一种，购买一定要有使用基础
2. 购买前请看好产品图片和描述，不然容易买错或造成损坏
3. 购买后，请按参数要求使用，否则必定会损坏
4. 供电电源很重要，直流产品必须是标准直流电压，(即有完整的整流、滤波、稳压)，否则没法使用或者会造成产品损坏
5. 注意输出接电池、电容的时，正负极请勿接反，接反直接报废
6. 接感性负载如风扇、电机等，启动电流大，请留有2-3倍的余量，即35W只能用到电流1-2A以内，功率大概10W以内
7. 升压使用时，如果输入电压低会输出受限


代码：

Specification:
Package weight
One package Weight 0.12kgs / 0.26lb
One Package Size 11.0cm * 8.0cm * 5.0cm / 4.33inch * 3.15inch * 1.97inch
Qty per Carton 120
Carton Weight 14.5kgs / 31.97lb
Carton Size 50cm * 37cm * 35cm / 19.69inch * 14.57inch * 13.78inch

代码：