SKU:

HANPOSE HPD332 2.2A 8-36V Stepper Motor Driver For 20 28 35 42 Motor
汉普思 HPD332 2.2A 8-36V 步进电机驱动器适用于 20 28 35 42电机
条码：6922150964737
HSCode：84852000
批量修改原始型号 		采购：Kitty  编辑：Celery  产品经理：Maura


1. HPD322 two-phase stepper motor driver is a cost-effective subdivision driver designed based on PI flow control algorithm. It has excellent performance, high speed and large torque output, low noise, low vibration and low heat.
2. The operating current and subdivision can be selected through the dial switch. There are 16 subdivisions and 16 currents to choose from. It has overvoltage, undervoltage, phase current and total current overcurrent protection. Its input and output control signals are all photoelectric. isolation.
3. Signal input: single-ended, pulse + direction and double pulse;
4. Built-in micro-subdivision; the maximum power supply can reach DC36V; the current is easy to set, 16 levels are optional, the output current peak can reach 2.2A; the current is halved after 1S of inactivity
5. Optically isolated differential signal input, the maximum input pulse frequency is 300KHz;
6. The pulse, direction and enable terminals all have constant current input functions and can be directly connected to the input signal without adding an external series resistor for voltage reduction and current limiting protection.
7. High reliability: using multi-layer boards and surface mount sealing, leaving sufficient margin for power devices
Suitable for 20, 28, 35, 39, 42 4, 6, 8-wire two-phase stepper motors

Usage environment
1. Do not place it next to other heating equipment. Avoid places with dust, oil, corrosive gases, excessive humidity and strong vibration. Combustible gases and conductive dust are prohibited.
2. Temperature: 0-50 degrees Celsius
3. Humidity: 40-90%RH
4. Vibration: 10-55 Hz/0.15mm
5. Storage temperature: -20-65 degrees Celsius
6. Weight: 180g
​

1. HPD322两相步进电机驱动器是基于PI流控制算法设计的高性价比细分型驱动器，具有优越的性能表现，高速大力矩输出，低噪音，低振动，低发热。
2. 可通过拨码开关选择运行电流和细分，有16种细分，16种电流供选择,具有过压，欠压，相电流和总电过流保护，其输入输出控制信号均采用光电隔离。
3. 信号输入：单端，脉冲+方向及双脉冲;
4. 内置微细分；供电最大可达DC36V；电流设定方便，16 档可选，输出电流峰值可达2.2A；静止1S 后电流减半
5. 光隔离差分信号输入，输入脉冲频率最大300KHz；
6. 脉冲，方向和使能端子都有恒流输入功能，可以直接连接输入信号，而不用外加串联电阻降压限流保护。
7. 高可靠性：采用多层板和表面贴封，功率器件留有足够余量
适配20、28、35、39、42的4，6，8线二相步进电机

使用环境
1. 不能放在其它发热的设备旁，要避免粉尘油污、腐蚀性气体 、湿度太大及强振动场所，禁止有可燃气体和导电灰尘
2. 温度：0-50摄氏度
3. 湿度：40-90%RH
4. 振动：10-55赫兹/0.15mm
5. 保存温度：-20-65摄氏度
6. 重量：180克
代码：

Specification:
Package weight
One package Weight 0.2kgs / 0.44lb
One Package Size 10.0cm * 7.0cm * 4.0cm / 3.94inch * 2.76inch * 1.57inch
Qty per Carton 150
Carton Weight 28.1kgs / 61.95lb
Carton Size 32cm * 37cm * 42cm / 12.6inch * 14.57inch * 16.54inch

代码：