null 产品型号： 侵权图库
提醒 2：该产品涉及专利问题，不能在Alibaba上发布！
型号：DIY5124     大类别：Consumer Electronics     第2级类别：DIY Parts & Components  -->子类别：Module   审核产品   所有审核和提问(new)  链接英文名称：TTGO LORA SX1278 ESP32 0.96 OLED 433Mhz WiFi Bluetooth Module for Arduino
中文名称：TTGO LORA32 433Mhz ESP32 0.96 寸屏蓝牙WIFI模块

颜色： 包装：Anti-Static Bag 配件： 装箱资料： 每箱：300pcs 重量：5.5kgs 外箱尺寸：36cm * 22cm * 22cm 采购:Dani  编辑:Shadow(2021-06-23)  美工:ganzhou_nico

给产品打分

       
Main features:
1. This product is based on the SX1278 chip of ESP32 WIFI enhanced OLED, namely LoRa remote modem, frequency 433-470MHz, high sensitivity over -148 dBm, +20 dBm output power, high reliability, long transmission distance.
2. Onboard 4Mt bytes (32 Mt bit) flash memory WiFi antenna, 0.96 inch blue OLED display, lithium battery charging circuit, CP2102 interface and USB serial chip, support Arduino development environment, can be used for program inspection and product development, convenient Fast.
3. The 433/470 antenna needs to be connected to the IPEX interface (if the antenna is not connected, the LoRa chip may be damaged)
4. Lithium battery charging and discharging circuit, when the battery is full, the blue LED will stop working. Please pay attention to the positive and negative poles of the battery when using it, otherwise it will be damaged!
5. Through the IO port touch screen touch signal input, you need to add a 100nF pull-down capacitor to this pin!

Product specifications:
1. Working voltage: 3.3-7 V
2. Operating temperature range: -40 to 90 degrees Celsius
3. Support Sniffer software protocol analysis, Station, SoftAP and WiFi Direct mode
4. Data rate: 150 Mbps for 11n HT40, 72 Mbps for 11n HT20, 54 Mbps for 11g, and 11 Mbps for 11b
5. Transmitting power: 19.5 dBm at 11.5 dB, 16.5 dBm at 11 g, 15.5 dBm at 11 n
6. The receiver sensitivity is up to -98 dBm
7. UDP continuous throughput: 135 Mbps
8. Delivery list: 1 X LORA SX1278 ESP32 with download chip version


中文描述：
主要特征：
1. 本产品是基于ESP32 WIFI增强型OLED的SX1278芯片，即LoRa远端调制解调器，频率433-470MHz，高灵敏度超过-148 dBm，+ 20 dBm输出功率，高可靠性，传输距离长。
2. 板载4Mt bytes (32 Mt bit)闪存WiFi天线，0.96英寸蓝色OLED显示屏，锂电池充电电路，CP2102接口和USB串行芯片，支持Arduino开发环境，可用于程序检查和产品开发，方便快捷。
3. 433/470天线需要与IPEX接口连接（如果天线没有连接，可能会损坏LoRa芯片）
4. 锂电池充放电电路，当电池充满时，蓝色LED将停止工作。使用时请注意电池的正负极，否则会损坏！
5. 通过IO端口触摸屏触摸信号输入，您需要在该引脚上添加100nF的下拉电容！

产品规格：
1. 工作电压：3.3-7 V
2. 工作温度范围：-40 到 90 摄氏度
3. 支持Sniffer软件协议分析，Station，SoftAP和WiFi Direct模式
4. 数据速率：在11n HT40时为150 Mbps，在11n HT20时为72 Mbps，在11g时为54 Mbps，在11b时为11 Mbps
5. 发射功率：11.5 dB时为19.5 dBm，11 g时为16.5 dBm，11 n时为15.5 dBm
6. 接收机灵敏度高达-98 dBm
7. UDP持续吞吐量：135 Mbps
8. 发货清单: 1 X LORA SX1278 ESP32带下载芯片版本



搜索关键词：32Mt bit (4MB) 433Mhz For Arduino

OEM/ODM are Welcome! we can make Customize design and print your logo