1. Higher ground clearance, smooth landing, to avoid ground debris during takeoff and landing dirty fuselage or damage to the gimbal 2. Part of the material selection of 3D printing technology, lightweight design process, can stabilize the fuselage, easy to fly without pressure 3. Adopting snap-on installation, quick installation and removal, saving time and labor 4. Flat design, can be easily stored in the bag, does not take up much space 5. Material: ABS + 3D plastic 6. Weight: about 43.5g 7. Unfolded size: about 17.9 x 16 x 8.5cm 8. Note: The product only includes the stand, not the demo drone
Quick Installation: 1. Insert the top part of the stand into the groove of the drone 2. Press the bottom tab of the stand to make it fit the drone
Quick disassembly: 1. Gently tilt the tabs on the bottom side of the kickstand up 2. Remove the top tab by pulling it out of the slot
中文描述：
1. 离地增高，落地平稳，避免起降期间地面杂物弄脏机身或损坏云台 2. 部分材质选用3D打印技术，轻量设计工艺，能够稳定承载机身，轻松飞行无压力 3. 采用扣合式安装，快装快拆，更省时省力 4. 采用扁平化设计，可以轻松收纳包里，不占空间 5. 材质：ABS+3D塑胶 6. 重量：约43.5克 7. 展开尺寸：约17.9 x 16 x 8.5cm 8. 注意：产品只包含支架，不含演示用的无人机
侵权图库
